Jim,3306,
Where are you in the construction stage??? If you already have completed the gunite stage, it it too late.
Jim R.
I see your location is Bedford. I’m in Keller, just down the road from you. I’m having an issue getting pressure to a newly built water sheen. I had three sheens installed in a new wall. The two sheens at either end work just fine, even at low RPM in a 3HP Intelliflow3. The middle sheen is my problem. It is raised about 6” higher than the other two. Even maxed out at 3450 RPM, it’ll flow, but not like the others, even then that’s closing my return and making my pool look like tidal waves. Any suggestions? If you want to stop by to put eyes on target, I’ll cover your gas lol