I didn't get much info from PB other than run the pump, keep the CH around 200, and keep the ph in check. Not sure what kind of start up I had.. they plastered yesterday and did an acid wash today and started filling.
Trying to create a plan.. here's what I'm thinking so far:
8.2+ PH
0.5 FC
2 CC
25 CH
300 TA
Trying to create a plan.. here's what I'm thinking so far:
- Fill
- Add sequestrant.
- Check PH and CH when full.
- Get PH below 7.8 with MA. Retest often.
- If CH is really low, add some deicer. Retest often.
- On day 3, add chlorine and CYA to 30ppm.
- Don't use heater for 2 weeks.
- Don't use robot for 2 weeks.
- Do brush, even though PB said not needed.
8.2+ PH
0.5 FC
2 CC
25 CH
300 TA
Last edited: