Hayward Max-flo VS SP2300ZLV NO POWER

You have 240 across the L1 and L2 screws on the pump?
This is where I'm at this afternoon. Breaker replaced. 240 at both poles at breaker. 240 at the end of the run. 240 across to L1 and L2 at pump. As shown. Still nothing. I do hear some clicks at the pump. Which is more than I got before
 

Attachments

  • 20221006_142432.jpg
    20221006_142432.jpg
    655.7 KB · Views: 11
  • 20221006_142653.jpg
    20221006_142653.jpg
    508 KB · Views: 11
You saved me a ton of money!
:goodjob:

TFP is commercial free and staffed by volunteers. Please consider donating to keep the TFP servers running so we can continue to assist you.

 
Yes , The same issue with me, 18" of wind driven rain here. Different motor, but same concept, IMO water intrusion to the main control board (in my case anyway). Just not adequate seal protections on these type of motor setups. I will be constructing a doghouse/shelter for my next vs pump.
Here's a look at my components and the main board on the motor. I dried them up/cleaned them up with no luck. Still dead. good luck to Ya.

Pete
While that control is no longer available, the V-Link wireless control for the V-Green is at a few places online.
 
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.