- May 20, 2018
- 49
- Pool Size
- 31000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
We have the pentair Ultratemp heat pump and Easytouch 4 for controller. I had been using the simple thermostat based control in the heater, but would like to limit the heater to run only during the day. As the PB didn't connect via rs485 during construction I'll do that. However, reading through the ET4 manual, I'm not sure I see the path from "here to there" to do what I'd like, assuming it is in fact possible with that combo.
Reading the manual and googling I get a vague notion that using a solar mode in the ET4 may be part of the mix, but was hoping someone here could clarify for me a bit?
Reading the manual and googling I get a vague notion that using a solar mode in the ET4 may be part of the mix, but was hoping someone here could clarify for me a bit?