Recent content by Wheats

I would treat your power supply with kid gloves. They don't appear to be the most internally robust builds. The folks at maytronics support suggested we keep the power supply in the house when not in use and definitely don't leave it outside when temps are expected to be below 50. Good luck

I looked at all the Dolphin models, including the m600 (which I really liked), but settled on the S300i. I really liked the specs of the M600 but I was pretty sure being wifi only there would be problems getting a decent enough signal out at the pool, even with a powerful router. We've had some...

Jim, That's the one...i'll verify the P/D version

Ping, I guess I'm just unlucky. Maytronics has been great in continuing to send out new units and acknowledge that there have been problems with the ones I've sent back. Maybe it's just a bad batch and I'll eventually get through them all.

Jim, That's the one. Wanna swap? Has anyone ever looked inside one of these?

Geebot, Almost flawlessly...that's kind of funny. Just for giggles this morning, I plugged in the power supply to a interior gfci to see if it would fire up. Shockingly it did power up, for about 15 seconds, before the blue lights quickly blinked and then it went dead again. My hopes were...

JW, The Pentair and S300i look very similar, if not identical. I would venture a guess that it's the same power supply.

Jim, No, power supply will not power up by itself without the robot plugged in. If you hit the power button, you get a nano second of blue lights and then nothing. Yesterday, we unboxed it, ran a full cycle in the pool, and put it away for the night. This morning, a dead power supply. However...

Well that's what we thought too, but we had the first one plugged into a different outlet than the last two power supplies. Both outlets were checked with a multimeter and checked out fine. The robot ran most of the afternoon yesterday without any problems. Brought the power supply into the...

We have had some tough luck with the S300i, specifically we are on our third robot in the last month and none of them have lasted even a day before breaking. Just received a new robot yesterday, put in the pool and everything was working great, full cycle, pool looked great. Went to start it up...