Recent content by tu212

Welp we're about half full finished it up this morning, what a pita lol. I wound up ordering 2 of the boots from inyopools we were able to shave back a piece of the track on the new boot and slip it in without taking anything else down. There was absolutely no clearance at all where the bottom...

I'm trying to slide the block and the old busted plate in there for now. Was gonna try to go a quarter of the way?

Thank you everyone, it's been gradual for the past couple years getting worse. I ordered the part but prob won't have it for 2-3 days how much water should I put back in to not kill the liner. Got a couple 90 degree days coming up Monday and Tuesday :(

Well I got the foot off had to phone a friend at the pool store lol def don't wanna be reusing this one lol. I was able to get most of the dent out from underneath by hand. Still gotta clean it up a bit

We have lift off. 3 paint scrapers and a screwdriver got it off lol. Wall looks much worse underneath got a nice dent.

That link is great here's the exact boot Wilbar Top Cap Oceanic Boot 10 (11 Pack) - 21381-Pack11 - INYOPools.com Looks like I'll be prying outward at those three clips! Hopefully better news tomorrow. If I don't have this thing filling by tomorrow night I'm gonna have some unhappy campers...

It's wierd cause the top one used hardware but the bottom one according to the manual and everything I can find online says it just snaps in by pushing down. There's no way to get inside the upright to depress the clips. I think I'll be calling the place I bought it in the morning :)

Well I figured out there issue but have a new one lol. The bottom resin cuffs have the uprights that just snap down into place. Well I can't release the cuff to get the upright out all I'm doing is trying to pull the cuff and bottom plate up with it. Google hasn't been too good gonna try a...

Andddddddd we still draining lol boy did I underestimate the ammt of time this was gonna take haha no prob just having a couple cold ones waiting :)

Thanks again guys! We're getting there :) Yea the tops are def resin. The lower wall rail I guess is aluminum or stainless. I prob got another hour or two left of draining this was no joke how long it's taking lol. My $35 Amazon pump I bought just for the cover paid for itself and then some...

Thank you again guys! Going to try this out on Saturday. I'm assuming they have to be stainless or they would have to be pretty rusted by now. I'll def be pulling off the top cap of the upright and prob both top rail pieces. Fingers crossed :)

Thank you! That's what I was figuring I was going to have to empty it :( Thankfully it's only about half full after the winter. I'm just wondering if that rail is going to be shot I know my pics aren't the greatest but they both look like they might have Twisted slightly on both sides of the...

Hi everyone! Looking for a bit of advice this is a doughboy 20 or 21' above ground pool that's been installed for approximately 5 years. This one upright has always had a slight issue since like the second year or so but noticed this year it appears to have gotten worse. As you can see the...

Well every thing is good the water is clear fc is still at 20 haven't put any bleach in since Monday night it's only been dropping like 2ppm per day. Thanks again everyone!

Little update, I vaccumed and brushed the whole pool yesterday and it got much cloudier after getting out but by this morning it was clear again, guess that's a good thing cause the skimmer will grab whatever was settled to the bottom. I tried pointing the return jet a little more toward the...