Recent content by Silva1181

Thanks. I will look into what you suggested.

Disregard. I just bought a new robotic cleaner. Do I need to cap off the Polaris hose cleaner wall jet or can I just leave it as an extra jet? Also, what do I do about the Polaris pump? Leave it as is or have it disconnected and safe-off the power? Thanks

I have a 14000 gallon, inground gunite pool. depth is 3ft on each side and a minimal slope to the center which is 6ft. I have 3 steps on one side a bench type step on the opposite side of the pool. over the past couple of months, my Polaris 280 hasn't been working properly and i am now...

Today I noticed my polaris cleaner is floating. It was working fine the past few days. I am hearing a hissing noise coming from the wall jet where the polaris hose is connected to. I disconnected the hose from the wall and the water pressure coming out of the wall seems low and even with the...

Appreciate the replies. Thanks

A little over 3 weeks ago I had some service done on my pool equipment. The tech replaced a leaking adaptor on the water line connected to the Polaris motor (see photo for adaptor replaced). The next day I noticed the cleaner was not moving as fast as before in the pool. I reached out to...

Thanks again.

All is it safe to let the pump/motor run under the current condition, until such time I can get a pool repair tech to my home middle of next week? Is there a risk of fire? With this heat and humidity I am sure my water will turn green quickly if I turn the pump off for a couple of days

Thanks for this detail.

Has never run dry. I run it 8 hours in winter and 10-12 hours now in summer. It’s been quiet and working with no issues since I last replaced it.