Recent content by Scottc19

Hi All - Looking for some guidance and feedback from the group. I have a raised spa setup for continuous spillover into the pool. Since opening this season, though, the spa is not consistently spilling over and spa level is dropping an inch or so below the spillover level. It will spillover...

Thanks for the guidance and direction. I’ll give this a try this season (pool opening on Thursday!) and see if it reduces acid consumption.

Should I have any concerns about keeping the pH on the higher side (around 8); I had always understood the target to be closer to 7.4 - 7.6. What I'm hearing, though, is that 8 is ok with my TA around 50. All of these parameters would keep my LSI at/around the right value.

Fill water has a pH of about 8.2 and TA of 50.

I don't know the answer for the fill water, but I can test it. Plaster is about to start its 4th year/pool season. Built in Spring 2021.

It does not stay in that range; it drops. I add about 10 - 15 lbs of baking soda, on average, per month.

Sure; thanks! Here's what I typically see (as measured by Taylor test kit): Alkalinity - 70 - 80 Calcium - 350 pH - Rises to about 8.2, 8.3 after a few days; acid bumps it down to about 7.3/7.4 CYA - 20 Chlorine - 3 - 5

Hi - Does anyone have any recent experience with CircuPool's Total Balance system for C02 injection as a means to lower pH? Searched other forum posts and most recent posts about this product are from 2019 or older. Curious if anyone has had recent good or bad experiences. pH Control I'm...

My pool cover collects rain water in three separate areas (two side of pool cover, and within a raised spa), which means pumping rain water from three discreet locations. Does a pump/product exists where I could run three “suction hoses” (one to each area of standing water) from a single...

Fair point. And I do have my own kit and do test on my own. But, being new too this, have used them for validation of my own results. We are usually pretty close. Thanks for the insight and perspective.

My pool builder / store operates a “water chemistry lab” where they have multiple testing stations at which employees run the full suite of pool water tests “manually” using various Taylor test reagents / drop tests. I understand the TFP community position on pool store testing, but given that...

New pool owner / first year maintaining myself and looking for insight on a sudden drop in chlorine levels. Chlorine has been stable all season between 3 and 4ppm; have salt water chlorine generator. Two days ago, added 7 pounds of calcium as levels were a little low (230ppm). The next day...

Appreciate the reply. Sorted it out. Ended up being a bit of moisture on the speaker ends I hadn’t yet terminated causing a bit of a short.

Recently installed the Monoprice Sycamore with four satellites around a new pool build, but I’m having an issue where the sound output to each satellite is very low, to the point where they can’t be heard from a foot or so away, with volume maxed out. Using a 200w amp with Amazon Alexa as the...