Recent content by mmcal

Jandy system, with the handheld PDA. When you mentioned 'EasyTouch', I though you were referring to the handheld PDA. I didn't realize it was a 'Pentair EasyTouch'.

Ya, I tried the reset button on the panel, it did not work. My in-house remote is the handheld Jandy PDA, I don't have a hard-wired or plug-in type in-house remote.

I've tried both the EasyTouch remote and also directly from the control panel. Neither one will allow the pool to run in Auto mode. I appreciate your time on this, thanks.

When the panel is set to Service, it is in pool mode on the panel, and the EasyTouch says it's in Service mode. However, when the panel is set to Auto, it only will go to Spa mode on the panel. On my EasyTouch, it shows 'Spa' is running. When I try to turn off the Spa on the EasyTouch, it will...

Hi Jim, Yes, I did try this. I disconnected the spa side switch inside the panel, however it did not fix the problem. The pool still won't stay on, it still switches to run the spa instead. Any other thoughts???

I have a Jandy Aquapure RS 1400, with a spa side switch. Right now when the pool program triggers the pool pump to turn on, it turns on, but instantly changes to Spa mode, and then the Spa runs instead of the pool. I can only run the pool mode from Service mode. I've checked the relay switches &...