Recent content by Mikekantro

thank you... any good way to plug up the old hole?? thanks again!

I haven't come across that recommendation yet - do you have any photos of what that would look like or other threads to point me to? thank you for your advice @bdavis466

maybe I can move the exit flow line after my SWG - perhaps that will create enough difference. Calling @JamesW Calling @bdavis466

the output, or exit, you can see on the second photo all the way on the bottom of the photo.Follow the exit of the UV all the way down to the bottom of the photo and you will see the black tubing going in. they may be no pressure differential because I'm bypassing the heater and the UV.

this is from the manual : Flow Cell Inlet and Exit Lines It is essential that the supply line be at a higher pressure than the discharge line so the water will flow through the cell at a steady rate in the right direction. Inlet should be installed after filter and before heater. Note: Plumb...

I like having the UV with the assumption I can maintain a relatively lower level of FC. The UV "came with the pool" before I knew anything about pools. I don't mind having it. It turns on with the main pump and I run the pump slowly at night to water is going through the UV all day/night. I get...

Did you try reseting the protocol adaptor? there's a small reset button the side (opposite the lights). if you put in a pin and hold it, it will reset the adaptor and you should be good to go.

I have an issue - and a question. Right after my multiport filter value there is about 12 inches of straight pipe and then a 3-way value that bypasses the heater. Now .... i notice that when i bypass my heater, my GPM on my VSF pump increases. This makes sense as I’m skipping the heater, and...

I noticed you have a setting for "either heater" is there a way to make sure the pump speed stays on a certain level when the heater is on? i am trying to make a schedule for the pump to change speeds throughout the day, similar to what you have done. Would love to chat in more detail if you...