Recent content by Lbray812

This is all very helpful. Thank you. Yes It was cut to size. But stays in the pool and too many curves. I’ll give that a go as well as the eyeball change!

Hi all I can’t get my Polaris 280 to clean this side of the pool. I swear I have tried every direction of the thrust. The Polaris refuses to go to the circled part of shallow end. Every time It is headed there It turns right. I have tried 9 o clock on the thrust. Nothing. Any other...

Hi all! Hope you had a good winter. I opened my pool recently, the algae wasn’t too bad actually. Water was still nice. Relatively clear. I thought I needed to Slam on every opening, So I started. It’s been 4 days and I seriously just can’t stop the spring time debris from falling into...

Yea I would love to add a layer of pavers that match the rest of the patio. It causes me problems this way with the cover too. The cover kills the grass every year. I stopped covering It.

Yes they are but I imagine not very deep. Maybe an inch or two. Should I just extend the rock into the mortar a few inches?

Hi there. I have a skimmer basket that is on grass. A previous contractor put pavers standing up around It and It looked hideous. I just pulled them out. Any ideas on what I can do around the square? I was thinking putting more coping stones around It but maybe overskill. What about some...

I have two setups. 2600 rpm for 10 hours a day and 3200 for 2 hours. My pool is very large and I have 2.5 inch pipes I made some adjustments and relubed my o ring on pump and my air pocket is gone.

I have my main drain valve and both skimmer valves open 100%. Sounds like this is wrong?

Thanks. In general, should i have the jets facing down to go deeper or up to agitate the water a bit?

Sorry. New to this! Pentair easytouch.

Will do Ty!

Yes I suppose those are my questions! Winds will mainly come from south west in the top left of the photo and I Noted.