Recent content by KMShaw

I had to wait for the rain to stop before I opened up the Aqualink box outside. With that said, S1-P5 is definitely in the “off” position. Does anybody else have any ideas?

I don’t think that’s unreasonable at all. People seem to forget about things when 6 months has gone by. Especially when there’s no money in it for them. I would absolutely ask for the light now.

Ahh, now I get it. Thank you. Mine is an older one and I’ve only got the the S1. Position 5 is the same for the older ones and the newer ones though. I’ll check that in the morning. Thanks

I know where the dip switches are, but I’m not sure I understand what you mean by “switch 1, position 5”

I had posted about a week ago about the board in my Aqualink being fried. I pulled it out and sent it to BP Electronics and he repaired it and got it back to me in a week. For $150, seems like a pretty good deal to me. Everything seems to be working fine, with the exception of one thing. He was...

I would unplug the low voltage connector going to the filter relay and see if your pump shuts off. That should determine proper function of the relay. I’m dealing with a similar issue right now with my RS8. The low voltage connector for the filter as well as “all” aux connectors are putting out...

Yes, I left it powered down overnight. No difference.

About a week ago my Aqualink RS8 started displaying a message saying “air sensor opened”. I assumed I had a bad air sensor and installed a new one. Unfortunately, that did not solve my problem. I then switched the air sensor with the water sensor and it was reading the current air temp on the...

I’m assuming you don’t put the Mastertemp in remote mode? Do you just use the local controls and then the fireman switch just kills power to the heater. I assume it remembers it settings when the Aqualink calls for heat again?

I’ve been lurking around the site for a while but this is actually my first post. Lots of great information here. I have a Jandy RS8 automation system controlling my pool and spa. I have an old Pentair Minimax NT pool heater controlled by the Jandy via a two wire connection. Well, the...