Recent content by Julie8000

Our pump circulates to our spa that then flows into the pool via infinity edge. The wall behind the spa and pool contains other waterfalls and is stacked stone. The edge of the wall with the spillway has started leaking when it runs every day. I have attached picture. The corner gets wet and...

Thanks. And can I mount the transformer in the actual easy touch box

Thanks. So we would mount this inside the easytouch box and then connect to aux relay and to the sprinkler valve, correct?

Hi @Jimrahbe I need to get the separate transformer for the Easy Touch 8 as thesprinkler valve fill was hooked up incorrectly. I saw something somewhere as to type to get. I believe you have your hooked up that way. Can you point me in the right direction. Thanks

My board was fried so once replaced it is working although the spa blower motor fried so need to replace that next

I will try and get pictures as we didn’t install the new board, so not sure if he did something weird or not.

Moved from here. Hi Jim. I saw this post and had a question. We have a similar set up that wasn’t working lately so we replaced the solenoid in the valve. We also just had a new motherboard on the easy touch8 installed. This afternoon I came out to pool fill running almost to overflow. It has a...

I will have to get my husband out there for a picture. Now the spa is running again no light on etc.

Jim We only have a wireless remote. since I posted it mysteriously stopped. But given the strange things occurring who knows. But if it does it again, what would I hit with a screwdriver If I have a wireless remote and where if I should still hit it. thanks.

Will try to make this short but weird things have happened. We were part of the big storm had 12 hour power failure but all started up fine.but all seemed to work correctly although the remote was sometimes acting up. Easytouch 8 is 15 years old Few days ago spa light and spa was on for no...

In Houston area. when our power went out on Monday we decided to shut off the breakers, to drain the pumps, and filter etc and the noodle treatment, cover the pipes. didnt do the heater as didn’t see the way to do it We haven’t used in years. Power came back 13 hours later but we figured no way...

Have a small leak coming from the screw on the bottom of the unit. The pool guy redid seals, gaskets etc and none of that is wet. The little thumb type white screw thing at bottom in the middle seems to be where it is leaking. Any idea on best way to proceed. Thanks.