Recent content by jonnyb3_94

  1. J

    Bonding new pool questions

    Will do. Thanks CJ
  2. J

    Bonding new pool questions

    My halo was gonna be one single piece. My pool is all resin so was only gonna bond the wall where it bolts together. Didn't want to drill holes in my wall and void my warranty.
  3. J

    Bonding new pool questions

    Getting ready to bond my all resin pool. I live in the country and have no codes or inspector to deal with but still want to do this right and only once!! My plan is bury 8 gauge solid bare copper wire around the the pool and connect it to itself with split bolt connector. Then I plan on coming...
  4. IMG_0356.jpg

    IMG_0356.jpg

  5. J

    Graded floor for deeper center?

    Here is my deeper bowl on a 27' round we just done today. Still got more sand to pack and screet but were getting closer. I would have liked to add a pad liner or the insulation board on top of the sand but just didn't see how it would work without causing wrinkles in the liner. The bottom of my...
  6. IMG_0333.jpg

    IMG_0333.jpg

  7. IMG_0332.jpg

    IMG_0332.jpg

  8. J

    Bonding with resin uprights and top

    Sorry I should have been more clear. Yes I am going to loop all around the pool and to the pump. Just wanted to know iF bonding to the wall in just one place (at the seam) instead of 3 more places to the wall. I am nervous about drilling 3 more holes in the pool wall if it is not necessary. If...
  9. J

    Bonding with resin uprights and top

    So I have a similar pool. All resin except for the wall. I live out in the country and have no codes or inspector to deal with. I was planning on bonding the skimmer water and where my pool bolts together. Will this be sufficient to eliminate shocks or do I need to add 3 more points and drill...
  10. J

    What is needed for new pool

    It's in my signature. We are gonna bowl the middle 18" or so. So that is my best guess until it actually gets done and filled.
  11. J

    What is needed for new pool

    Hopefully getting around to setting up my new pool in my signature very soon. Anyone have a ballpark number of how much bleach, muratic acid, cya, and anything else I will need to have on hand for start up?
  12. J

    Where to buy salt??

    Menards has the cheapest salt I could find anywhere
  13. J

    Suggestions for new salt water pool

    After reading on here all day I'm leaning towards the cartridge filter. I'm guessing if i bowl the bottom of a 27' round pool it will be in the 18000-19000 gallon range. Is a 190 sq ft filter big enough for this pool. It is the biggest one the pool factory lists in their packages. It is a...
  14. J

    Suggestions for new salt water pool

    Probably 3-4 ft of flat all the way around