Recent content by JohnDib

James. I want to thank you for your help and advise. I did check the stack flue temperature sensor with a good ohmmeter And it was not working. I did replace it and the heater worked good. Thank you

Thank you again. Will check these next week. I do have a question. How do we check the wires from the circuit board to the sensor to make sure that they are not damaged. have a great evening. Thank you

thank you James for your help Before the heater even fires, I did press and hold the Pool On button and the stack flue temperature displayed 40 then 80 then 40...then 80 5 min after the heater started, the stack flue temp displayed 271-273. Please advise. Thank you

More info, today I opened the heater and cleaned it and unplugged /then plugged the sensor after cleaning the dust. I also want to say that after starting the heater, the temp went up to 92, the target temp, the heater stopped. Then when the temp started to go down, the Heater started again with...

Hi James, I did start the heater today, and when I started it, And I did press and hold the "Pool On" button. The temperature was 160 and started going up to 200+, the changes back to water Temp. Thank you.

OK. Which one should I hold, Spa or Pool; or doesn’t matter. Also, what should I expect to see, normally. Thank you

I have a Sta-Rite Max-E-Therm 400 heater for my Pool&Sps. When I turn it on, it works good. Once it reach the set temperature, it will stop as it is supposed to. When the temperature drops below the set temperature, it will start again, however, sometimes, the heater will not start and giver...

thank you. Appreciate it. Very helpful

Thank you James for this explanation. therefore using 073128 impeller for my1.65 total HP capacity should be ok and I do not need 073129.

Thank you HP =1.5; SF= 1.1; Total HP=1.65

Thank you James for this explanation. therefore using 073128 impeller for my1.65 total HP capacity should be ok and I do not need 073129.

Hi I replaced my pool pump couple weeks ago. I recognized that I used 1HP impeller for Century 1.5 HP motor (B2854) Can I use 1hp impeller with 1.5hp motor. I placed on it the following impeller: 073128, which Is 1Hp full and 1.5 up. Please advise it is ok or I must change. Thank you.