Recent content by jbilliel

I just replaced the capacitor and that was it. Thank you all!

Sounds like a plan. If the cap doesn't do it, I will then go about replacing the fan.

I also updated the original post as I referenced run and meant to say fan.

Correct - Combo capacitor. I checked all three sides and they tested out ok, but I will buy a new capacitor and try it since its only $20

Team - I know enough to be dangerous, but I need another set of eyes on this. I have a aquacomfort heat pump. The pump is 4 years old and after starting it up today for the first time I noticed that the compressor is kicking on, but the Fan is not. I gave it a love tap and then it started...

Dang - so I am back to option 3

I was going to buy a pentair superflow vs the Intelliflo. Let me see if there is a similar option with the SuperFlo

I have a 27' AGP with a single speed pump and I follow the TFP method of using liquid chlorine. This year I would like to transition to a VSP and install a salt water system. At the moment I have a manual timer that runs the single speed pump. It appears that I have a few different solutions...

I live in CT with the highest electric rates in the country and considering moving to a variable speed pump on my 27' AGP. Currently I have a 1.5hp hayward 240v pump on a manual timer and an "integrated" Hayward cartridge filter. If I go with a 1.5hp VS pump will it be ok to plumb it into the...

Any other tricks to finding a leak in the vinyl liner other than the food coloring or pool leak dye?

My AGP has been covered for 1.5 months and noticed the other day the the cover was way too low. Much to my surprise there is only 1 foot of water in the pool. I immediately pulled the cover off to prevent it from pulling in the side. I then got my waders on to see if I could find the leak and...

The blue thing is a pool alarm that floats on the water and makes noise if there is a wave. Totally unrelated to this issue

pH was measured with the TF100 Test Kit. I am not using pucks. Just liquid chlorine...

I opened my pool for the year and its been running for 2 weeks. It's crystal clear and ran all my tests this weekend, but not sure what the right approach should be to correct the pH without adding more Alk. Any thoughts? pH - 6.6 Alk - 90 FC - 6.0 CA - 30 CH - 75 This is an above ground...

will do!