Recent content by Hachu

Thank you

Thanks. I'll try that and see.

Yes, I've always held verticle with no pressure and yes, I noticed the TF r0009 bottle gives very small drops so I'm not sure how to record my TA since my Taylor kit is giving 70ppm while my TF IS 110ppm.

Hi, I recently bought the TF test kits refills for my K20006C. When using my Taylor K-2006C to test my TA I get 70ppm, but when using the TF test I kept getting 110ppm. The results are always higher when I use the TF. Now, I'm just confused with the test results. Has anyone have this problem...

Hmm..I didn't manually turn off the bubbler when I switched from Poool Mode to Spa Mode. I will turn the bubbler to off position next time I run Spa mode and see if that works. Thank you.

I had the filter pump set at 2800 and Spa speed at 2900. Thank you for the link. I'll check it out. I don't see any air bubbles coming out of return lines though. However, I do see air bubbles in the spa if I turned on the air bubbles and then turn it off, I see air bubbles after that where...

Hello, I've been getting air bubbles in my filter pump when I turn on Spa Mode and also PSI goes up about 8psi compared to pool mode.. When I run on Pool Mode, there is no air bubbles at all. This started happening right after the TX freeze. The only thing I had to replace after the freeze was...

Updating... we got a new polaris booster pump put in by a pool tech. He used the Polaris tube instead of the big, round 4" pvc pipes (see picture of the new install). Does it matter which is used? Is there one better than the other?

Thank you.

I have the same question also. I hope someone can answer on here.

I usually google everything first.. Did I just skip this one? 😳 thank you :)

Thanks :)

Hi, I left a bottle of Muratic Acid outside in a single digit freezing temperature. Do you think it is still safe to use? Thank you.