Recent content by Gr33nPool

An update: I removed the inoperable and ancient pool heater and the issue I had appears to have gone away. It could be a coincidence, but the removal was a good choice nevertheless, I think--the heater used copper pipes and when I removed them from the heater the ends of the pipes basically...

Thank you, James W. I am unable to check any metrics while the pump is running--when off I can see PSI set as 30 within the Filter menu option. There is a heater, however, it doesn't work.

Thank you everyone for your contributions. Here are some more details in response: - The pump and filter are out of direct sunlight - The cartridge filters are clean (I gave them a spray and also soaked them over night in TSP, then sprayed with the hose again, all last week), the filters may be...

I have a Pentair IntelliFlor VF variable speed pump and an in-ground, chlorinated pool. I'm running the pump on Filter Mode. The watts output of the pump, after priming, first rests at about 240 but increases at a rate of about 10 w per hour. Is this a sign of a problem elsewhere? I don't know...

Thank you. The crew finished the acid wash a few hours before the pictures were taken.

Thank you. Yes, the valve that feeds the autofill was next to a hose bib attached to the house near the pool (but away from the pump equipment area).

Hi All, I just had mini pebble installed and it looks spread a little too thin to me. The pool surface seems almost blotchy--pool not yet filled with water. See pictures. Is this normal? Thank you!

Hi All, I'm planning on draining my pool so that I can wash it out. I need to shut the water off to the pool, but I can't figure out how to do that without shutting off the water to the house, which I don't want to do. I see two (and only two!) valves on the pool plumbing, but I don't know what...