Recent content by flair3366

Ok so I have an Intex 18x52 XTR with 1 return and 2 inlets or vice versa. I installed a wide mouth skimmer and now want to shut off the 2 inlets. I'm going to cut out the 1 1/4 size holes to make them 1 1/2 size holes (I know I know). My question is what do I need to buy to close off those 2 holes?

Thank you very much..

Hi All, I'm wanting to have a new Intex 18x52 XTR pool installed but can't seem to find a contractor to do the ground prep and install in Greensboro. Any suggestions??

Hi all, I have an Intex 15x48 prism frame pool that I'm replacing next week with a 18x52 XTR frame pool. Heres my problem, the drain plug on the old pool somehow got rotated down to where It can't be used to hook up a water hose and drain. The only thought I have had is rent a sump pump. I was...

Hi Jim, The saltwater causing the rust was something a guy at my pool store told me. Maybe I need a new pool store. So if I just set the pump to Filter Pump (FP) then I should be able to run the chlorine tabs in it? Randy

Hi everyone, I'm pretty new to all of this. I have an Intex 15x48 pool with an Intex pump and saltwater system. In the last couple years I've noticed rusting on the frame so I'm wanting to convert back to chlorine. Problem is that i'm not sure how to accomplish this. Do I take the saltwater...

Thank you Kellyfair. Your Pool looks great. When you cut your two suction holes, what fittings did you insert for those holes. I know it's 1 1/2 inch but not sure which one to get, I'm really new to this. Below is a pic from my pool. I already cut the return hole to be 1 1/2 and put in a...

Hi All, I have an Intex 15x48 Ultra Frame pool with a sand filter and saltwater system at 1500 GPH. I have one inlet and 2 returns on the pool. All three of these were 1 1/4 inch fittings. On the inlet i cut the liner (very carefully), to make it 1 1/2 inch. Should I also do this on the 2...

Hi All, I have an Intex 15x48 and over a couple months one side has dropped about 2". Any suggestions on how to get this back level without draining the entire pool? Thanks Randy

Hi everyone, I need some help. I have an Intex 15x48 prism frame pool. This year I upgraded the filter pump to a Sand filter and Saltwater system. When I was setting this up I noticed as I loosened the screw on top of the skimmer to release air, it sounds like a plane taking off. Usually after...