Recent content by drknapp

Whew! Thought I had done something wrong on my end. Thanks for the update.

I think this is what is going on. My pool temp is hovering just below 60 (58,59). Then in the afternoon (we are having much warmer temps than normal) the temp climbs to 60, 61 (actually hit 64 today). That's what was throwing me a curve. It looked like it was working when I went to...

Thanks, That's what I thought. Mine is shutting down at about the two hour mark, but the panel is indicating all is operating correctly (except current is 0 and no instantaneous salt reading). I have a Circupool T-15 (CIR-GEN15 ) Replacement cell that is just under one year old. As soon as I...

I have an older Goldline Aquarite SWG which I know is now Hayward. It's running r1.4 firmware. I think I understand the cycle time on these is supposed to be 2 hours. What I'm not clear on (And I've done a lot of reading posts and info pages). If I have mine set to 100% and it runs for over...

I believe it's there to help vent any trapped air out the return line.

Mine has and indicator light also. But to make sure I don't miss it I put an event on my Google calendar to remind me every three months to pull it and hose it out. (I tend to build up some calcium with my CH levels.)

My TA is currently 70. I'll try to get it lowered a bit below 70. I'm about to go restock on MA.

My CH is currently 575. Pool Math suggests my upper target level is 550 and my max safe range is 650. I've seen it mentioned here that you don't have to worry about it until it hits 800. I found quite a bit of calcium build up in our SWG when I cleaned it recently. I was wondering if I even...

Here's what I used for the thermistor when I had to repair ours: https://www.amazon.com/gp/product/B06ZY4W8P4/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

MIne goes into the skimmer also. That doesn't look finished to me. I would be worried about water getting behind the tile that's there and loosening it up over time.

All you can do is keep your pump running, vacuum the bottom (as needed) clean your filter as needed and keep your chlorine levels up. We had a mess when we had our trees removed. We followed the SLAM method, cleaned everything from the bottom we could and ran our filter continuously. We...

Just donated also! I've learned so much from this site and our pool has never looked so good!