Recent content by Dock Ellis

It came up on the app. I would start a cycle and the robot would move about an inch then stop and throw off that error code. I purchased it from Marina last January. Called Aqua Products and they said the cable is only covered for a year. Good news is after I posted that I went back at it...

Has anyone had to replace their cable? I keep getting the error code 10 which I assume means there is a short somewhere in the cable. I ordered a replacement and now I can't figure out how to access the motor and there are surprisingly zero videos on YouTube for it.

Sorry for the delay Jim, finally back at work. So the transformer to the panel was powered from the GFCI outlet, which was powered by the breaker I replaced. That's what I can't make sense of. Maybe the redundancy caused an issue? It never has in my residential applications but that's all I...

I recently added 3 Pentair landscape lights and when wiring them in with the pool lights on the ET panel noticed that the breaker was not GFCI protected. I also couldn't get power to the new landscape light transformer by using a jumper wire from the pool light spot at AUX 5 to AUX 2 where I...

My app recently stopped working with my Dolphin and now it is prompting me to enter the serial number, which it says can be found by removing the filter on the robot. The problem is I can’t find it anywhere and the manual is also no help. Anyone know how to find it? I’ve tried using the serial...

Looks great! These types of pools are always inspiring to see that you can have a really nice pool and spa for a reasonable price. Everybody knows you're still hanging around McKinney a little bit.

Only the hot tub, too cheap to heat the pool! It's been great though. We went with the Laguna as well. It seemed to take a few weeks before the plaster started to sparkle but it looks great. We had a great experience with TNT, I'm sure they will take good care of you.

Glad you caught that before they were able to install. That is the same plaster I chose, you can see it on my build thread. My wife and I love it.

And just like that I believe we are finished. Got the landscaping wrapped up yesterday and also had the pecan tree removed last week. It made me sad to do but life has been so much better since we made the decision. Thanks to all for the input and help on the various issues that have arisen...

Looking good. Much like Lebowski's rug really tied the room together, that star is a nice touch.

Thanks Jim! Moved the wires over to water, took the heater apart and turned on the gas on the internal switch and fired up the hot tub. I think everything is finally working properly. Now we've just got outdoor kitchen and landscape before everything is finally wrapped up.

It looks like the probes are connected to solar and air. Should the solar have been connected to water?

Jim to the rescue, once again. Thank you sir! Both were set to pump 1, so I updated and it is working correctly now. Alright I've got one more issue for now. I can't get the heater to kick on. When I turn it on in the Pool section and set it to 80 degrees the heater doesn't power up. I'm...