Recent content by CypressTx

Same issue here. I even upgraded to the ScreenLogic Connect on my iOS to 7.7 that was recently released but still won't connect via WIFI, but works fine from REMOTE. Tried doing the 3 push reset button trick, power cycling everything, no go so far.

I'm glad I found this thread - i've been troubleshooting this off and on for a few days thinking I had a new issue and rebooting everything didn't help. I did see the upgrade to 7.7 in my Apple Store and upgraded, but it's still "Waiting for WIFI" indefinitely. Anyone else still stuck?

Thanks Jim! As an IT guy, I'm a little embarrassed I didn't first try a "reboot" of all the pool equipment :oops:. That resolved it, so it was likely just the outside antenna after all. Now, if you can tell me how to fix the crazy flickering of my 8ish year old Pentair Intellibright lights (I...

Oh hmm! I guess I've never paid attention to the light before :unsure:. The only reason I thought it was because it's not working and I'm used to green = good, red = bad in most cases. I will try resetting the breaker tomorrow on the pool equipment tomorrow, thanks Jim.

Hi all, We had a bit of storms recently and my protocol adapter has a solid red light now. Tried power cycling, holding reset button in, etc. Anything else to try before I call it fried?

Disregard, got it with Pentairs help. Didn't know about the 3-push trick on the reset button.

Anyone? I am still struggling. Still stuck at "Connecting to Relay Server at 69:94:nn:nn:7576" I'm guessing some filtering on my AT&T router but still not finding anything else to turn off on it.

Just from internet searches, might've even been an old post from this site's forums, i'd have to search again, but it's good to know it's not required at least! So it just sits at "Connecting to Relay Server at 69.94.xx.xx:7576 (it actually shows a valid IP, I just didn't know if it was mine so...

Hi all, I'm having a problem connecting from remote to my Screenlogic. I can connect on wifi with no issues. When I try to connect remotely it says "ERROR: Cannot connect. Error #60 in connect(): A transmission timeout occurs during a read attempt" For what it's worth, I can't connect to...

Hi all, I'm a 16x32 rectangle pool owner in Texas. I'm using liquid chlorine from a local chlorine bulk seller for $2.75/gallon (10% strength). I was born with a bit of a quirk - I prefer to swim fully clothed vs wearing a typical swimsuit. A typical "swimsuit" for me consists of a long...

First - I clean my filters every 3-4 months. Every time I have this big pile of lint. We do tend to wear a beyond abnormally excessive amount of clothes in the pool. Any harm? Second - what’s the easiest way to prime my pentair intelliflo after cleaning - I’ve battled this challenge for...

I’m using a keto-ai smart skimmer but my Taylor and Leslies read the same. To clarify, I didn’t get to test the alkalinity while the pH was >8. But my pH climbs daily and I add acid every other day roughly to keep my under 8. I probably need to test TA more often but I tend to test it when the...

I used my Taylor kit and then had Leslies check it too.

Hi all, 15k gallon non-salt water pool. My TA was low 4 weeks ago (30) so I added 16lbs of baking soda. The pH kept rising to 8+ super fast after that so I kept adding muriatic acid to bring it back down. Today I tested my TA again and it's only 47, so I added 4lbs baking soda. My pH is rising...