Recent content by RedSkip

240V - makes sense to me now. Sorry for the confusion.

Edit: All, sorry for typing/speaking poorly, I was at an appointment today and typing on my phone in the lobby. The SWCG is already hooked up and running. There was a comment in the thread that if I connect the SWCG to a GFCI breaker like I have it wired today, it would trip the breaker...

Is it safe to assume the follow if I were to install the GCFI CB myself? 1. Pump Neutral to CB 2. Pump Ground to Ground Bus 3. Hot (2) to the CB 4. Neutral from CB to Neutral Bus For the SWCG that only has 2 hots and ground: 1. Hot1 to Pump Relay - Load 1 (2nd terminal block on relay) 2. Hot2...

Cadillac, thank you kindly!

Hi Jim, Didn't think of wiring it for 240V, I assume the logic is the same as mentioned above but utilize both sides of the "Load/out" on the relay. I don't believe the breaker is GFIC, there is no "test" button on the breaker itself. Edit: The breaker is a Homeline, DP-4075 30A, I don't...

Wanted to reach out and see if my thought process is correct, appreciate your time in advance. Question: When wiring a SWG to 120V from the pump relay, is it safe to assume that the 2nd and 4th wiring terminals are the "load/out" side of the relay and the 1st and 3rd terminal lugs are the...

Understood, appreciate the feedback.

I want to preface the discussion with I am not a Chemist... Sodium Hypochlorite's chemical formula is NaClO. When breaking down organic compounds (killing) in a pool, is the "NaCl" portion of the formula spent, the "ClO", or is it the Oxygen that helps sterilize the bacteria? I'm curious if...

So, I turned off all the power the panel (flipped breakers) and let the system sit for 2 minutes. Flipped all the breakers on, and the pumped primed and went into its normal RPM speed setting for the current Time of Day. Currently running 1553 rpms according to the controller, whereas before...

I recently had a Hayward TriStar SP32950VSP installed in January-21. Last night I noticed the pool water wasn't spilling over the spa which made me think it was just a start/stop issue from changing speeds on the controller. This morning, I noticed the spa wasn't spilling over again, and...

Jim, Does the constant power to the pump remain true if it’s a Hayward VSP and not a Pentair? Brad

Just replying to myself so folks don't invest more of their time. I had a loose load wire on the Remote Display terminal block. Powered the unit down, waited 2 minutes, pulled the terminal block, tightened the loose load wire, waited the remainder of my 2 minute countdown, reverse steps and...

Thanks Jim, appreciate your time. Ironically, I have a fault code on the VSP too now. I'll check the wiring behind the terminal block in case I loosened a wire. ("Filter VSP Comm Error") Reading past posts I have a feeling you may have helped with this in a prior thread as well. Our VSP...

I have three available wires, two are connected to the relay currently. I have enough slack in the jacketed com wire to splice the green and connect it to the relay. Photo attached.