Recent content by Bauer600

This is the only thing I can’t verify since the pool builder replaced it under their 3 year warranty when we built the pool.

2nd Jandy 1400 cell in less than 4 years this one only about 1 1/2 years old throwing a 120 code but still producing bubbles on and off, even after cleaning. Connectors/pins look clean and great. This one was replaced under warranty, but the 3 years manufacture warranty expired last July 2024...

I’m on my second replacement, first failed at 2 years(replaced under warranty) and now my second one is 15 months old and started getting intermittent general faults (121 error) I just acid cleaned it for the first time a little over a month ago.

Does anybody know when a Jandy PLC1400 is replaced under warranty, (3 years in this case since it was bundled, but first cell failed after 2 years, if the new cell carries a new 3 year warranty, or the existing 3 year warranty still applies from the original install date regardless?

Hi All, We've had our pool for almost 2 years in July. We have 3 lights in the pool, unfortunately the middle one fell outta sync. By reading this forum my guess is one or two of the LED colors have failed? I've put it in service mode and switched it on / off for 5 seconds in which all 3 reset...

Never actually paid attention to this. I’ve noticed bubbles from a couple returns when the pump typically starts up for the first time in the day, almost like it’s pushing out air bubbles, but then it goes away, but outside of that no. My SWG is only a year old, haven’t cleaned it for the first...

So I got the FC up to 7.5/8 using LC last night around 8:30 tested at 9:30 PM, let it run overnight even with the SWG at 100% just to see if it would produce overnight and stay steady. I had a chlorine loss down to 5.5/6 FC at 7 AM. Water has seemed “crystal clear” for the past couple days, but...

I ran it overnight at 100% and this morning at 10 am, we’re still at 0.5 FC. Hmmmm

Sounds good, this is our second year with it and the summer months have been tricky trying to get the levels to stay sustained only using the Jandy Aquapure 14000 Sounds good, these summer months have been tricky trying to get sustained levels only using the SWG, I know every environment is...

Yeah, it’s trial by error right now, it’s been set at 8.5 hours in the spring with no problem, but obviously the summer heat is different and Wed to adjust. I’m just trying to gauge the sweet point of you will.

Here in North Texas, salt water pool, we’ve had quite the heat stretch the last month over 100 Each day, and our pool constantly gets 11-12 hours of direct sun a day. I’m having to run the SWG at 100% lately just to even TRY to keep up, typically I would be running the pump 8 1/2 hours a day...

I haven’t tried removing the jets. They’re screwed in there pretty good, would need a wrench to get some leverage to get them off. Here is the best picture I have.