Recent content by Analogbytes

I am not completely sure I can, but Ill try

6 returns currently. Adding a picture of the pool below. Landscaping is still on the list. The in wall cleaner port is right where the bare spot is on the right. Thinking maybe a fountain, jet, or something. The bare spot is where the previous morons had tampered glass pieces/shards. I...

I would get the IntelliCenter, if I didn't have a one year old ET at my previous house to swap with this house. What about converting the in wall cleaner line to a return for a water feature?

Upgraded house, upgraded pool. Need to refresh the equipment pad though. Things I know I am going to add: EasyTouch 8 with ScreenLogic IntelliChlor IC40 Intelliflo VS Heater Bypass Plumbing IntelliValves Here is the current pad setup. I have an additional pump available to me, either...

20amp GFCI is pump and SWG. The 15amp GFCI will be pool lights once I hook them up. Breaker is just in there for now. Didn't even hook up the pig tail.

Makes sense. Thanks again!

this should be better. Pump is left, surge is middle, line is right.

The curly is on the neutral bus. I was concerned by not having a load neutral(middle connector on breaker) connected to the GFCI breaker that it wouldn't work. However, yours doesn't have a load neutral either.

Line from main goes to the lugs. The bottom breaker is for surge.

Sorry for the confusion, the ET definitely has a neutral. The pump doesnt take a neutral. It takes L1, L2(low), L2(high), and ground.

Thanks for all your input. I replaced the wire this weekend with 10 gauge and got everything but the pool lights wired and running. Attaching picture just because. Question: I bought a GFCI breaker for my 2 speed pump motor, however, it does not have a neutral wire running to it. In that...