Recent content by Adidascu

  1. A

    Rolling black outs possible NTX

    Mine too...and I'm at work....
  2. A

    Pump screeching when cold

    I'm in little elm too. Mine is also whining. I'm running mine at 1550 RPM and it's been on for about 3 days straight and looking at over 7 total once this Crud blows thru. I'm quite worried about Sunday thru Tuesday. 3 to 6 inches of snow and a Monday high of 14 and a low of 1... Yes 1...
  3. A

    Jandy pump full of air after 5 hours.

    I have found that to happen from time to time (annoying), however it was not the issue this time. The pump area with the clear top had no water before the unit turned on.
  4. A

    Jandy pump full of air after 5 hours.

    I run my pump in the wee hours of the morning. I just went out to do my chems today and turned on the pump only to hear it run but push no water. The attached picture is while it was running. At the very end of the 3 minute priming cycle it finally started pulling water. I had turned the...
  5. 20201111_140920.jpg


  6. A

    How to properly use the TABS hopper for a week's vacation.

    Hey all. New here. Been following the advice here for some time and have been pleased. I found my CYA to be over 100 at the beginning of summer. No pucks since then. So far CYA is down to a more manageable 60. I'd like to get it closer to 40. I'm currently using 1 to 2 quarts a day of...
  7. 20200730_092334.jpg


  8. 20200730_092330.jpg


  9. A

    Cleaned filters... Algae??

    I'm using a Taylor k2005 test kit. I have looked over the ABCs
  10. A

    Cleaned filters... Algae??

    I cleaned my filters today. It was done about 6 weeks prior. This is a different color than last time I cleaned. It's been hot here in the DFW and a few months ago, I noticed my once a week chlorine (dicholor) was gone or nearly gone the following week so I started checking and adding twice a...
  11. 20200627_143735.jpg


  12. 20200629_123735.jpg


  13. 20200629_191446.jpg