Latest activity Postings Media Albums About
-
-
JoyfulNoise replied to the thread static shock from the trex deck?.Trex is a composite material made of wood fibers and recycled plastics (plastic bags and shrink wrap). Has it been dry out lately... -
JoyfulNoise replied to the thread Flow Issue (Help!).You probably need new filter cartridges at this point. Adding any form of clarifier or floc to a cartridge filter system is a recipe...
-
JoyfulNoise reacted to 1poolman1's post in the thread Hayward Heater Smoking and Smelling, but working.. with
Like.
A heater shouldn't look like that, even after years of use. If I were called out to service it, I would not put it back into service... -
JoyfulNoise replied to the thread Pentair Mastertemp 400 controls.Almost all heaters work this way. Thermostatic control via a closed relay is the only way to make heater control available to all...
-
Your automation is the ET. The heater is a dumb device. By using the firemans switch, you simply are turning the heater on and off via...
-
JoyfulNoise replied to the thread Pre pool opening (white water mold).My guess would be freeze/thaw damage on the pipe that’s buried in the concrete. No way to fix that unless you break up the decking...
-
JoyfulNoise reacted to Newdude's post in the thread 12 May 2024 Equipment and Controls While Thin Set Dries with Like.
They were laying my filter plumbing the same as they always do, in front. I asked them to use the back so the drain was in the front...
-
JoyfulNoise reacted to ajw22's post in the thread 12 May 2024 Equipment and Controls While Thin Set Dries with Like.
Be mindful of where the heater exhausts to. Check your local codes on the distance between the heater exhaust and any openings in the...
-
JoyfulNoise replied to the thread 12 May 2024 Equipment and Controls While Thin Set Dries.The filter is going to be way more maintenance than the heater (hopefully). I would have the filter set in a position where it is the...
-
JoyfulNoise replied to the thread Advice on Coping Repairs.Just slapping cement on top won’t really work and it’s going to spall off pretty quickly. The only topcoat treatment you could do that...
-
JoyfulNoise replied to the thread Confused about pool heater btu recommendations.Are you on natural gas or propane?
-
JoyfulNoise replied to the thread Pentair MasterTemp 400 manifold replacement question....Are you sure it's the manifold assembly that's leaking and not the heat exchanger? Maybe post a picture of what you're seeing. I...
-
JoyfulNoise reacted to Dirk's post in the thread Never thought I'd ever have to worry but I need outdoor security cameras! with Like.
Money can be better spent on alarm/security systems, for sure. Other than the slight deterrent mine might provide, I didn't really...
-
JoyfulNoise replied to the thread Pre pool opening (white water mold).If you are at SLAM chlorine levels then there’s no way WWM could be alive, it’s simply too fragile. However, in areas of poor...
-
JoyfulNoise replied to the thread Pre pool opening (white water mold).White water mold looks like strings or pieces of wet toilet paper floating in the water. It also will cling to internal pipe surfaces...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…