Latest activity Postings Media Albums About
-
-
mknauss replied to the thread Featured Multiple SLAM attempts.You should also try to run the pump at a lower rpm. Without a heater I suggest you try 1200 rpm and see if that skims the surface of the... -
mknauss replied to the thread Dry Acid in Saltwater Plaster pool.Welcome to the forum! No worries on the small amount used. Just use MA from now on. I suggest you read through Pool Care Basics -...
-
mknauss replied to the thread Featured Is a pool refill best option in my case?.No. You will need to follow the That is a start. It is likely at least the pH reagent of your existing kit could be compromised due to...
-
mknauss replied to the thread Featured Is a pool refill best option in my case?.I believe you need to go back to the basics. Read You need to follow the . Likely you will need a drain/refill before that, but you...
-
mknauss replied to the thread Green Algae.Did you pass the three criteria specified in the article? How are you testing your pool water chemistry?
-
mknauss replied to the thread Green Algae.Follow the
-
mknauss replied to the thread PH and alkalinity.With a TA of 110-120 -- no need to add borax. The pH will rise, quickly. Just leave the cover off.
-
mknauss replied to the thread Flow too low for heater....Turn phone sideways.
-
mknauss replied to the thread Hi. Armin from Iran.Welcome to the forum! I suggest you read through Pool Care Basics - Trouble Free Pool and even look at a few of our videos TFP-TV -...
-
mknauss reacted to jasondestiny11's post in the thread Intellichlor IC40 SWG Falsely Reporting 7500 ppm salt level (true level is 3,000ppm), not outputting Chlorine, and High Salt light is flashing. with
Like.
Update: I replaced the SWG with a Brand New IC40 and it resolved my issue. There is no longer a high salt flashing light and The Salt... -
mknauss replied to the thread Is this Iron?.Put polyfill in the skimmer basket. See if it turns brown
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…