Opened pool for second time after 3 years.

that makes sense. Last question before I do this, should I add in more liquid shock before doing the stabilizer if my FC is low again? Or should I do stabilizer first then liquid chlorine?
Chlorine is always priority one, so add chlorine immediately to prevent any nasties from starting to take hold due to low FC. 👍
 
should I add in more liquid shock before doing the stabilizer if my FC is low again?
Yes, you can add chlorine. You never want it below 2-3 ppm. I would take the FC up to the 5-7 range for this evening. It should be getting dark soon for you, so that helps with no sun. As soon as the stabilizer from the socks is dissolved, you can balance the FC to the CYA goal as noted on the FC/CYA Levels. Now after all of this, you may decide to do another Overnight Chlorine Loss Test, if not in the next day or two perhaps on the weekend, just to be safe. But with stabilizer in the water, the FC should hold much better as long as algae hasn't tried to grow.
 
I added
Yes, you can add chlorine. You never want it below 2-3 ppm. I would take the FC up to the 5-7 range for this evening. It should be getting dark soon for you, so that helps with no sun. As soon as the stabilizer from the socks is dissolved, you can balance the FC to the CYA goal as noted on the FC/CYA Levels. Now after all of this, you may decide to do another Overnight Chlorine Loss Test, if not in the next day or two perhaps on the weekend, just to be safe. But with stabilizer in the water, the FC should hold much better as long as algae hasn't tried to grow.
i added in the stabilizer this morning, using the sock method. I did a CYA test before and it was showing nothing so I used pool calculator and did about 8 pounds of it. How long should I wait to retest, and what are the next steps chemical wise?
 
Hi so I tested my water chemistry, and here are the following results. Keep in mind I added in about 9 lbs of stabilizer 24 hours ago because we had none, and heavy rain yesterday. I read that stabilizer doesn't fully dissolve for a week so I didn't check it today since it's been 24 hours. Pool is crystal clear, just some run off dirt at bottom from storm and landscaping.

FC: 3
pH: 7
Alkalinity: 50ppm
CA hardness:40 ppm

How can I proceed?
 

Enjoying this content?

Support TFP with a donation.

Give Support
Hi, I purchased a Taylor k2006 FAS DPD. Initial tests using this kit had shown zero stabilizer and constant fc loss, so then I added in liquid chlorine 12.5 and 9 lbs of granule cya using sock method. Did an over night chlorine test and we only lost 0.5.

Stabilizer has been circulating for 24 hours and here are my current results. I didn't test CYA since I read it takes a few days for it to fully dissolve and I didn't want to waste my limited quantity of reagent. Pool is clear, just some dirt from rain storm and landscaping. What would you advise to proceed?


FC: 3
pH: 7
Alkalinity: 50ppm
CA hardness:40 ppm

How can I proceed?
 
What size is your pool? You may have said it in another thread, but your signature is still blank. :poke: That will tell us what your CYA should be by adding 9 lbs worth. It doesn't take several days for the CYA to show. If you used the sock method and squeezed it all out, the CYA should be close to its goal in 24-48 hrs.

Having said that, we need to know your CYA becasue as it stands right now, your FC appears to be extremely low as noted on the FC/CYA Levels. You may have passed an OCLT previously, but if you don't get the FC up ASAP that could change quickly in the summer.

So right now I would add about 3-4 ppm of liquid chlorine then test your CYA tomorrow under some good sunlight. Then we'll know more.
 
would that be fine?
Wait until tomorrow. It's best to test the CYA under a sunny sky with the sun behind you over your shoulders while you hold the viewing tube at waist level. Tomorrow will be better - weather permitting.
 

Enjoying this content?

Support TFP with a donation.

Give Support
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.