Any Omnilogic experts in here? System on endless bootup

[citznfish]

Any Omnilogic experts here? I'm having an issue with an endless boot cycle

I am not sure what is going on with my unit. (installed 9 years ago)

We went away for the weekend. At some point the Omnilogic board stopped communicating with the network. Looked like a bad RJ45 cable based on my tester. I tried to find the break in the cable to repair it but no luck.

All I did was unplug the RJ45 cable, cut it where I thought the break was, installed a new plug and plugged it back in.

Now the OmniLogic is in an endless boot up. It just says "loading" on the screen. Resets. Loading...resets...loading..resets.

Not sure what would cause this. Not sure what to do now.

I did shut it off by the breaker a few times. Now I'm leaving the breaker off for an hour and will try flipping it on again to see what happens.

Maybe I can reinstall the latest firmware from USB? But I think I need to be able to get into the system to do that, which I cannot do now.

 

[ajw22]

HI, you ever get your OmniLogic out of the loop?

 

[citznfish]

HI, you ever get your OmniLogic out of the loop?

Yes. I have a bad network cable and when I unplugged it from the head unit the OmniLogic finally booted up completely.

I am not sure why the bad cable caused this, that part doesn't make sense to me.

Now I have the pleasure of pulling a new cable. Fun times, lol!

 

[Threepalmsoasis]

I had this happen. Had to completely shut down the power at the breakers for 20 seconds. Then it came back up (crashed during 4.8.0 firmware update)