ScreenLogic: no spa, but spa keeps showing back up

[aug0211]

Wasn’t sure where to put this or how to phrase it - this could also be why my search didn’t return any results

I have an EZTouch panel driving a MasterTemp 400 used to heat a pool. No spa involved.

I must have something set up incorrectly, because “Spa” keeps showing up in my ScreenLogic app.

Spa in SLConfig is set to do not show. Then I open SL app and it is hidden, as expected. Wait a bit, open up SL app, and Spa shows back up. Then check in SLConfig and the setting is back to “show on Spa”. If I flip the setting it works for a bit, then reverts and shows up again.

Can you tell me where I’ve gone wrong?

 

[Rancho Cost-a-Lotta]

Have you figured this out yet?

Since you received no responses, I'll give your thread a bump for my eyes.

Best wishes!

 

[aug0211]

Thank you! I haven’t heard anything or figured this out quite yet.

I keep re-hiding it in the SLConfig app and it works for a bit then shows up again. What’s the definition of insanity again?

 

[mknauss]

Is the Easytouch a Pool/Spa system?

 

[aug0211]

Is the Easytouch a Pool/Spa system?

Yes it is, but only have a pool.

 

[mknauss]

Then I suspect the Spa section will always show. I doubt you can eliminate it, just ignore it.

 

[aug0211]

Then I suspect the Spa section will always show. I doubt you can eliminate it, just ignore it.

Bummer. Seems odd that SLConfig has an option to hide it - and that it works temporarily, and just doesn’t stick.

 

[mknauss]

I looked at the ET guide and nothing there implicates you can 'disable' the Spa Mode. So the SLConfig app is just dealing with itself. And I suspect the ET then overrides it.