Coping width, is this too wide?

Jump to latest Follow Reply
PearlJamFan

PearlJamFan

Active member
May 11, 2021
37
Las Vegas, NV
Pool Size
12500
Surface
Plaster
Chlorine
Salt Water Generator
SWG Type
Jandy Truclear / Ei
Ordering some shellstone for my coping and pavers. The shellstone designer chose a 36" length with a 20" width for the coping and 1.5" depth. Is this normal? 3/4 around the pool will be coping only with synthetic turf abutting it.
 
Last edited:
Depends on the width of your bond beam it is going on and how you are going to create an expansion joint between the coping and the ground.

Expansion Joints and Coping - Further Reading

www.troublefreepool.com www.troublefreepool.com

Post pics of your pool the coping is going on.
 

Attachments

  • timelapse.png
    timelapse.png
    176.2 KB · Views: 40
How wide is the bond beam on your spa and pool??
 
With 20" wide coping how will you handle the overhang on the raised bond beam spa?
 
You need to figure out how you will do the expansion joint round the pool and the coping overhand on the spa.

You don't want the coping overhang on the inside of the spa that people will be sitting up against.

My opinion is coping stones on the spa should be the width of the bond beam and not have any overhang.
 

Enjoying this content?

Support TFP with a donation.

Give Support
You must log in or register to reply here.
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Top Bottom
Back
Jump to latest Follow Reply