ok so i am totally annoyed about this. Long story... I had a new variable speed pump and salt cell installed and in doing so Leslie's raised the manifold (see pics below) for the cell. I didn't think much of this at the time but I noticed that when the pump is not on, the water from the spa will fill the pool. It's a slow drain, you can't tell right away but you can see from the (wet) water line that it is dropping. It will not drain the spa entirely, it drops it to the bench where you would normally sit and below the jets. To remediate this I turn the pump on a low setting at noon and raise the spa again for a few hours and turn off again. I thought the raised manifold was the culprit so i cut everything down yesterday in hopes that would solve my problem and sadly this is not the case. Maybe the 2 have nothing to do with each other ?? I took apart the one way jandy valve and it looks fine, it springs back and forth like it should. I dont know what else to do. I am all ears if anyone has any suggestions here.
thanks
thanks