Hi all,
i have a Pentair CVA 24 with an issue. The valve won’t energize to turn on my water feature. If I turn on the water feature (I have a Jandy AquaLink) then I over ride the value to the open position, all is well. When on, I then put it back into the auto position. When I turn off the water feature through the Jandy, the valve closes. So, something is wrong with it initially engaging.
so, I tried the following
- I bought new micro switches and replaced, it didn’t work
- I took a working micro switch from another working valve and still no good.
- I took the capacitor out of a workIng valve to see if it was it, no good
- I took the connector from the jandy board off, reinserted to see if any issue and no good
any thoughts from anyone who may of seen this type of issue? I am think it could be the mini control board in the valve but I am not confident. Thanks
i have a Pentair CVA 24 with an issue. The valve won’t energize to turn on my water feature. If I turn on the water feature (I have a Jandy AquaLink) then I over ride the value to the open position, all is well. When on, I then put it back into the auto position. When I turn off the water feature through the Jandy, the valve closes. So, something is wrong with it initially engaging.
so, I tried the following
- I bought new micro switches and replaced, it didn’t work
- I took a working micro switch from another working valve and still no good.
- I took the capacitor out of a workIng valve to see if it was it, no good
- I took the connector from the jandy board off, reinserted to see if any issue and no good
any thoughts from anyone who may of seen this type of issue? I am think it could be the mini control board in the valve but I am not confident. Thanks