Swapping Intermatic Pool Timer with DEWENWILS WiFi Box (WiOn). Wiring Help needed.

ZuluDancer

Member
Apr 10, 2020
10
Orlando, Florida
I've had some bad luck with my aging Intermatic Timer and wanted to try to go Digital with some automation functionality.
This set up seems tightly wired, but I'm still having intermittent issues. I can't manually turn things on, the Wifi turns on and off, and I think the box is just resetting constantly

The old set up did have on less jumper wire... but that may not mean much since it's a different box altogether.

If anyone thinks they can make any sense I'd greatly appreciate it.
The two cyan wires come from the electricity and the red and black are from the 2HP pump.

The pump can operate at 220v (if that matters).

Thanks for anyone who can help with this.



20200410_171357.jpg


20200411_155917.jpg
 
The wiring looks correct according to the diagram on the Amazon listing...


You have a link to the installation manual?

The reviews on Amazon are mixed and some folks had flakey problems and needed to get replacements.
 
Here's how mine is set up. Unless things have changed, jumpers should be set up as shown in this photo:
20180518_074520.jpg


Line in from the breaker go to "L" and "N" (Intermatic timer terminals 1 and 3.

Load lines go to "NO1" and "NO2" on the wifi timer (Intermatic timer terminals 2 and 4). Green ground wires are attached to the terminal at the back of the box.
20180518_173442.jpg



20180518_065307.jpg
 
Last edited:
NC is normally closed.

NO is normally open.
 
First image there didn't appear- if you could post your picture, I'd appreciate.
There should be three photos: one showing jumpers only, one showing completed wiring, one showing a wiring diagram. They're all showing on my end. Let me know which one you can't see and I'll try to repost.

Looking at your wiring, it looks correct (taking into consideration the locations of the jumpers), But I'll defer to Allen and his experience.
 
There should be three photos: one showing jumpers only, one showing completed wiring, one showing a wiring diagram. They're all showing on my end. Let me know which one you can't see and I'll try to repost.

Looking at your wiring, it looks correct (taking into consideration the locations of the jumpers), But I'll defer to Allen and his experience.
For some reason can only see the third. The first two have broken image icons.
 

Enjoying this content?

Support TFP with a donation.

Give Support
I don't think it's related to your problem, but when I received my unit I removed the module from the box. The wire from the external antenna to the back of the circuit board was disconnected. I connected it prior to my install, and didn't have any problems with getting it to work properly. If your box won't even stay on, you probably have bigger problems. Good luck.
 
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.