- Dec 7, 2012
- 20
I have a salt water pool and an automated system that I control from a panel inside my house. This past summer I replaced the computer board on my main control panel outside. Until a few weeks ago everything was running fine. I started getting a check system light that came on and it was reading very low salt levels. I added a bag of salt like I normally would and the salt level didn’t go up. A week later it’s still reading low and saying I need more salt. I took a water sample to the local pool place and he said my salt level was fine as was everything else. My salt level is reading 1900 on the panel when it’s actually a little over 3000. Im getting the same warning light and salt level reading on my control panel inside and on the main board outside. Is this simply a case of my cell going bad? I cleaned my cell a few months back so it should be good but the cell is older. I don’t remember exactly how old it is though. What should I do at this point?