K so went back yesterday and played and the wife got in!!!! Even went off the diving board ?
Now, several of things I need to deal with. First, I've got an error message on the pool pilot.
"WARNING! Low Amps, Cell?". I ran the self test and it shows 3000 ppm salt, 80 degree water temp, cell volt of 24 and 0.7 Amps. Troubleshooting sticker says may be an incoming voltage problem? If the voltage was 28-29 volts and low Amps it might be low salt or dead cell, of the voltage is low I'm supposed to check the incoming line voltage. I know I checked it at the booster pump which is on the same circuit and after the main pump and it was 240. I can check again though.
Second, the water slide is looking rough. I need to replacing the spray fittings and refinish the surface. I did a quick search here and on YouTube and didn't see many good suggestions. Does anyone have any resources for refi having a slide?
Lastly, I'm going to pressure wash the slide and pool deck and get some kind of new paint on the deck. Any suggestions there?