That’s the point of this whole thread.Why does it say 0%?
foozed,
Most of us are fellow pool owners who want to try to help you. JamesW is literally an Expert. There is almost no one else on this site who knows the stuff he knows. You should report back (with screenshots) on his question regarding- can you change the percent input? Make sure you exit that screen and come back to see that it holds what you think you changed it to (e.g. from 40% to 20%). And program a non-zero value for the Spa on the Aquapure page of iAqualink, so that we know the 0% on the Status screen is not coming from spa mode.
I think you need to set it in the iAqualink interface, not on the panel.
View attachment 82419
- - - Updated - - -
When you enter that number are you hitting "enter"?
- - - Updated - - -
View attachment 82423
- - - Updated - - -
FYI: Once you change the # on the iAqualink interface and hit "enter", you will hear a "beep" come from the actual panel confirming it got the input.
- - - Updated - - -
Also I note in your picture above the "Spa" is highlighted and not "Pool". Make sure you select "Pool".
Wow - thanks! Called Jandy and within 60 seconds he recognized I have no water temp sensor on the aqualink (my builder forgot to install one).Make sure there is a good connection between your multiplexer board and the main board. Should be a 4 wire connection between those 2.
Pool temp open means your temperature gauge is not working or not connected. I had to do mine myself the PB was incompetent. I am not sure this is related to the Aquapure not working but could be.
Mine isn't physically present because my PB is similar to yours.