| Line 1: | Line 1: | ||
=Hayward OmniLogic= | =Hayward OmniLogic= | ||
==OmniLogic VS Pump Communication== | ==OmniLogic VS Pump Communication== | ||
| + | [[File:OmniLogic Low Speed Communications Bus.jpg|thumb|OmniLogic Low Speed Communications Bus]] | ||
| + | [[File:Hayward Ecostar Comm Ports.jpg|thumb|Ecosstar Comm Poprts]] | ||
| + | HUA is Hayward Unique Address that the VS pumps possess. | ||
| − | + | COMBUS 7 in the pump connects to terminal 2 on the green plug in the Omnilogic. COMBUS 8 in the pump connects to terminal 3 on the green plug in the Omnilogic. | |
| + | |||
| + | 1 & 2 green plugs are actually the same and you can connect to either one. | ||
| + | |||
| + | If you have an issue getting OmniLogic to recognize a pump HUA note that the low speed bus numbers are read R to L instead of L to R. You should wire the communication in the following order on the LS Bus, 4,3,2,1. | ||
| + | |||
| + | ==OnminLogic Drops Connection Between Pool and Pump== | ||
| + | If you find that the HUA of the pump being recognized in the Omnilogic unit matched the HUA of the Ecostar pump itself but the pump does not turn on then the OmniLogic may have lost the connection.<ref>https://www.troublefreepool.com/threads/omnilogic-ecostar-pump-control-not-working.167372/post-1477743</ref> | ||
| + | |||
| + | Then go back into the config wizard and you may find the pool had no pump assigned to it. If so select the pump from the drop down menu while in config wizard, save, reboot. | ||
| + | |||
| + | Sometimes it does that with power surges or power cycles or if you are going in and making changes "too much" in the config wizard. | ||
Revision as of 21:27, 18 September 2019
Hayward OmniLogic
OmniLogic VS Pump Communication
HUA is Hayward Unique Address that the VS pumps possess.
COMBUS 7 in the pump connects to terminal 2 on the green plug in the Omnilogic. COMBUS 8 in the pump connects to terminal 3 on the green plug in the Omnilogic.
1 & 2 green plugs are actually the same and you can connect to either one.
If you have an issue getting OmniLogic to recognize a pump HUA note that the low speed bus numbers are read R to L instead of L to R. You should wire the communication in the following order on the LS Bus, 4,3,2,1.
OnminLogic Drops Connection Between Pool and Pump
If you find that the HUA of the pump being recognized in the Omnilogic unit matched the HUA of the Ecostar pump itself but the pump does not turn on then the OmniLogic may have lost the connection.[1]
Then go back into the config wizard and you may find the pool had no pump assigned to it. If so select the pump from the drop down menu while in config wizard, save, reboot.
Sometimes it does that with power surges or power cycles or if you are going in and making changes "too much" in the config wizard.
