Wiring Intellichlor IC40 to Intellicenter

Jump to latest Follow Reply
D

DaPoolDude402

New member
Sep 1, 2023
4
Houston
Hello,

I am looking for assistance on how to wire the IC40 SWG into our Intellicenter. Power center has been mounted and wires run. Filter pump is IntelliFlo VSF and is currently wired directly into the breaker. I just want to make sure the photo (with markups) is the correct way to rewire the VSP to the relay along with the SWG.
  1. Remove pump wires from Breaker and move to FP Relay Slot 2 and 4,
  2. Add Wires from Breaker to FP Relay slots 1 and 3,
  3. Connect SWG wires to FP Relay slots 2 and 4
Any help would be appreciated. Thank you.

1724253447155.png
 
Da,

VS pumps get constant AC power.. They do NOT get power from the load side of the pump/filter relay.

Your IC40 MUST get AC power from the load side of the pump/filter relay.

Thanks,

Jim R.
 
IntelliChlor Power Center high voltage must be connected through a knockout on the bottom and not run through left side low voltage area as the picture shows.

CB power connects to pump/filter relay LINE screws 1 & 3.

VS pump connects to LINE screws 1 & 3.

IntelliChlor Power Center connects to LOAD screws 2 & 4.
 
You must log in or register to reply here.
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Top Bottom
Back
Jump to latest Follow Reply