Wifi heater control installation DTH101. Help please.

[grey1988]

Hi, I am trying to install this item

Amazon.com: Wi-Fi Gas Heater Pool Spa Hot tub programmable Thermostat/Timer Remote/Receiver & Control Temperature : Industrial & Scientific

Amazon.com: Wi-Fi Gas Heater Pool Spa Hot tub programmable Thermostat/Timer Remote/Receiver & Control Temperature : Industrial & Scientific

www.amazon.com

I have to connect to 2 wires to the heater control but I'm not sure where they are on this control board or even if I'm looking the right place. They also have a temperature sensor and I'm not sure where it goes either. My heater is an old Hayward H400IDL. I am attaching a picture of the control board because I don't see the pool/spa remote connections. I will also attach the manual they sent me. Please help if possible. For the 2 heater control and temperate sensor do I have to put those in the conduit that is already run to the heater? I don't think they will both fit.



Thanks in advance

 

[mknauss]

Let's ask @ajw22 if he can guide you on what you need to do.

 

[ajw22]

You have an H400IDL not a H400IDL2. They are different with different manuals and boards.

Your manual is here --> Hayward H250IDL Installation, Operation And Service Instructions (Page 18 of 88) | ManualsLib

See page 18 which describes where to find the remote terminal block near the electrical inlet.

You do NOT run low voltage wires in the came conduit as high voltage wires.

 

[grey1988]

Thanks Allen and Marty, Ok that makes more sense.

 

[grey1988]

Hi, I still can't find where to connect the 2 wires to the H400IDL. I don't see it in the diagram. Please help

Thanks

 

[ajw22]

Hi, I still can't find where to connect the 2 wires to the H400IDL. I don't see it in the diagram. Please help

Thanks