I just opened my pool an hour ago, i noticed a spot about the side of a dinner plate and a few squishy spots next to it on my liner wall just below the water line. What is my best course of action?
Water behind liner after opening pool
- Thread starter jamjam
- Start date
- Jun 22, 2014
- 52,086
- Pool Size
- 17888
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- CircuPool RJ-45 Plus
How old is your liner? I would recommend posting a couple pics of the bulging area and the top of the wall/trim/coping at the top of the liner. That could influence the best course of action.
- Apr 14, 2022
- 25
- Pool Size
- 40000
- Surface
- Vinyl
- Chlorine
- Salt Water Generator
- SWG Type
- Jandy Aquapure 1400
Liner is 1 and a half years old. The water was cloudy so the picture didn’t come out well. I’ll try again.
I used a broom handle to squeegee the bubble up over the water line and I think it spread out so it’s almost not noticeable but still squishy to the touch.
I was trying to get the liner out of the track and see if I can direct the water up and over. But I can’t get it out.
The other thing I can try is force the water down? To the bottom where it can drain.
I used a broom handle to squeegee the bubble up over the water line and I think it spread out so it’s almost not noticeable but still squishy to the touch.
I was trying to get the liner out of the track and see if I can direct the water up and over. But I can’t get it out.
The other thing I can try is force the water down? To the bottom where it can drain.
Similar threads
