Opened the pool up starting last Sunday. Everything seems fine but the fc is very high 30+ (I stopped there because I was using a ton of reagent).
pH was 7.0 raised to 7.4
CYA was at 0 so I raised to 50.
TA 50
FC 30+ for 2 days now without adding chlorine. I've knly added 4 gallons total of 10% liquid chlorine since I've opened it. Had pump running about 75% of the time it's been open. Water is very clear and not irritating to swim in. I have ordered fresh reagents but same fc test results. Pool almost feels just barely slimey in some areas but not really and could just be baking soda, stabilizer, sand etc.
Whats up with the high free chlorine reading?
Also it seems a Bobby pin left some rust stains on my liner in a few spots. Is there anyway to clean these off?
pH was 7.0 raised to 7.4
CYA was at 0 so I raised to 50.
TA 50
FC 30+ for 2 days now without adding chlorine. I've knly added 4 gallons total of 10% liquid chlorine since I've opened it. Had pump running about 75% of the time it's been open. Water is very clear and not irritating to swim in. I have ordered fresh reagents but same fc test results. Pool almost feels just barely slimey in some areas but not really and could just be baking soda, stabilizer, sand etc.
Whats up with the high free chlorine reading?
Also it seems a Bobby pin left some rust stains on my liner in a few spots. Is there anyway to clean these off?