- Oct 10, 2018
- 12
- Pool Size
- 33000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Jandy Aquapure 1400
My CYA and CH are insanely high so I'll be doing a draining and re-filling of my pool. I'm going to take advantage and scrub all the waterline tile as there is a lot of scaling. I bought De-scale it and a pumice stone and then finish it off with a good power wash. Going to take apart the DE filter and clean it as well. Should I go rent a pump from Home Depot to drain it, or will doing it through the waste function on my system be ok? What do I need to do after the pool fills up again?
My latest test results using the TFT test kit:
FC - 1.0
pH - 8.2
TA - 110
CH - 950
CYA - 80
CSI - 0.96
Specs on my pool - inground chlorine pool with spa ~12.5K gallons.
Equipment - All Pentair with automation, quad DE filter, 3.0 hp pump, air blower, 400k BTU heater.
My latest test results using the TFT test kit:
FC - 1.0
pH - 8.2
TA - 110
CH - 950
CYA - 80
CSI - 0.96
Specs on my pool - inground chlorine pool with spa ~12.5K gallons.
Equipment - All Pentair with automation, quad DE filter, 3.0 hp pump, air blower, 400k BTU heater.