I have a Pentair 400 Heater that Temp Displaying the number 1 after it would kick on and the afte about 3-5 mins and it then displays E01 error code and then shuts off. I recently replaced the Thermistor and also the Automatic Gas Shutoff Switch. I was going to purchase a Thermal Regulator to see if this solves the problem. Any recommendations as I am new to owning a pool.
Temp Displaying 1 would fire for about 3-5 mins and then displays E01 error code
- Thread starter joerock56
- Start date
- Jul 21, 2013
- 53,119
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Welcome to TFP.
This post implies you may have a bad control board...
www.troublefreepool.com
I suspect that you're going to need:
42002-0007S Control Board and
472610Z Membrane Pad.
This post implies you may have a bad control board...
Pentair Mastertemp E01 Error Code
I started having a random, erratic problem with my 2yr old Pentair Mastertemp 400 natural gas heater in October. Using either the EasyTouch keypad, or my Pentair ScreenLogic app on my iPhone, I turn the spa on... give it a minute or two, then turn on the heater. System goes into Spa mode...
www.troublefreepool.com
I suspect that you're going to need:
42002-0007S Control Board and
472610Z Membrane Pad.