Hello everyone. Been reading and lurking on the board for the past few weeks while our pool is being built.
I’ll update my signature with my pool equipment very soon.
25,000+ gunite pool. All Penair equipment with SWG.
All the equipment was set this week and we’re scheduled for the plaster guys on Monday.
Really excited we are getting close.
In anticipation of filling the pool next week I did a test of my tap water.
I got a result that I was surprised about.
I used the TF-100 test kit and I also purchased a Hach Pocket Pro+.
Here are the results from my tap water.
FC 1.0
CC 0.0
CH 75
TA 40
CYA 0
PH Just under 8.2
Thought the PH didn’t make sense. I grabbed the HACH and got a reading of 8.17
Still didn’t believe it would be that high.
Grabbed the singlets of ph buffer solution (7.0) used for calibration and the HACH came in at 7.01 on it.
So all evidence points to this being correct.
Just looking for any thoughts....
Thanks in advance.
I’ll update my signature with my pool equipment very soon.
25,000+ gunite pool. All Penair equipment with SWG.
All the equipment was set this week and we’re scheduled for the plaster guys on Monday.
Really excited we are getting close.
In anticipation of filling the pool next week I did a test of my tap water.
I got a result that I was surprised about.
I used the TF-100 test kit and I also purchased a Hach Pocket Pro+.
Here are the results from my tap water.
FC 1.0
CC 0.0
CH 75
TA 40
CYA 0
PH Just under 8.2
Thought the PH didn’t make sense. I grabbed the HACH and got a reading of 8.17
Still didn’t believe it would be that high.
Grabbed the singlets of ph buffer solution (7.0) used for calibration and the HACH came in at 7.01 on it.
So all evidence points to this being correct.
Just looking for any thoughts....
Thanks in advance.