I will be using my existing Intermatic ET1725C which was used for my Stenner pump for wiring my RJ45+ SWG. My Stenner was plugged into the top left outlet which was connected to term 3 and 4. I removed those wires that controlled the Stenner outlet so I could connect the SWG to those terminals. (I didn't order the 110 plug option & changed the voltage on the controller to 120) The outlet on the right has the bottom plug hot and the top plug connected to term 5 and 6 and now both left outlets are hot. Now I don't have power on term 3 and 4 when it's programmed to come on of if I manually turn it on. Do I need to swap the black and white wire on the RJ45+? I wanted to get an answer before trying it since I don't want to damage the controller.