I am in the process of installing a new SWG that I just purchased and have a couple of questions about the combination of two speed motors and SWG's. I currently have the Hayward super pump spx2610x15 pump and motor setup. Motor is a 1.5 hp 56j frame 115v setup. I would like to swap it out for a 3/4 or 1 hp. two speed motor in the same voltage. I do not currently have any type of timer. i have looked at motors with the built in timers, but i do not believe the SWG can be configured to turn on or off at the same time as the timer without installing an external timer (intermatic,etc) and calibrating both units to function on off at the same time. Could I possibly wire the SWG into the pump timer control and have it power on and off with the pump? If not what would be my best options as far as a external timer to run the two speed pump and SWG together. I have looked at the Century Centurion b2981, although it shows as a 56y frame? I assume an extra wire would have to be run from the pump motor to the timer to allow for the two speeds. The SWG purchased was a Circupool si-45+. Thanks