Went to hop in our spa today (we're in the mid-60s after a month of single digits!) and noticed the spillover was running after I turned on the spa to heat. I figured the valve just didn't kick off, so I went to check (we use Hayward Omnilogic controls) and the valve looked like it was off. I have a valve override programmed in (there is a built in spa mode/spillover interlock that won't let the spillover run when spa pump is on) and toggled that. Watched the valve turn to the on position. Turned it back off, verified the valve handle moved to off position, but spillover still on. No matter what the position of the actuator, water is coming through the spa returns and running the spillover.
Is there any simple way to troubleshoot this? Should I take the actuator off and then turn manually?
Everything is working fine otherwise. There is a check valve plumbed in, so I can still use the spa if turn the pool filter pump off, but I really want to get this fixed as soon as possible.
We just had the pool installed this past summer, so everything is new. Last time I know for certain that everything was working correctly was the first week of January (I verified that all the balances were working when everything iced over).
Is there any simple way to troubleshoot this? Should I take the actuator off and then turn manually?
Everything is working fine otherwise. There is a check valve plumbed in, so I can still use the spa if turn the pool filter pump off, but I really want to get this fixed as soon as possible.
We just had the pool installed this past summer, so everything is new. Last time I know for certain that everything was working correctly was the first week of January (I verified that all the balances were working when everything iced over).