I have a schedule set in ScreenLogic for my pump to run from 8:00 am to 8:00 pm every day. Last night for the first time since installation a little over a year ago the pump did not turn off at 8:00 and ran through the night. Any ideas?
ScreenLogic issue
- Thread starter SteveK52
- Start date
Steve,
My guess is that sometime during the day you manually turned the pump on or off.. When you manually do something to a scheduled item, depending on when you do it, it can confuse the system and it will just continue on until the next time it is scheduled to turn on or off.
This is an EasyTouch issue, not a ScreenLogic issue.
Thanks,
Jim R.
My guess is that sometime during the day you manually turned the pump on or off.. When you manually do something to a scheduled item, depending on when you do it, it can confuse the system and it will just continue on until the next time it is scheduled to turn on or off.
This is an EasyTouch issue, not a ScreenLogic issue.
Thanks,
Jim R.
Jim,
I thought about that however it was never shut off and if I look at the history I see a continuous line.
Steve
Steve,
Have you added any new schedules, or made any changes in the last few days?
The IntelliFlo is controlled by a data cable, so it can't be something like a stuck relay..
Go out and look at the pump's display, it should say "Display Not Active".. If it does not, it means that the pump is no longer under the control of the EasyTouch.
Thanks,
Jim R.
Have you added any new schedules, or made any changes in the last few days?
The IntelliFlo is controlled by a data cable, so it can't be something like a stuck relay..
Go out and look at the pump's display, it should say "Display Not Active".. If it does not, it means that the pump is no longer under the control of the EasyTouch.
Thanks,
Jim R.
Jim,
I will look at the display however, after turning it off at approximately 6:30 this morning it came back on as scheduled at 8:00. I will monitor it and maybe it will never happen again.
Steve
Similar threads
